Added a new model to the range . Its single fin Mid Length design , called the Mid Strength. This one features a green resint tint . Super fun board ,designed to catch plenty of waves.Read more about it in the link below.

Learn more

Its relatively easy to design and make a "fast" surfboard . The theories are well known and really not a big secret .

Short , wide , plenty of foam with flat rockers are some of the key features , that will provide plenty of speed in small weak waves.
The art of surfboard design is how you compl...

Read More
Learn more

Surfboards "BUILT TO LAST & DESIGNED TO PERFORM". Proudly Made in Australia.

Our surfboards are handmade at our solar powered factory on the Gold Coast. The boards are custom made , we can design and create the exact specifications that you require. We strive to manufa...

Read More
Learn more

Lets take a look out the "Pin Tail"

Pin Tails

This is designed for maximum traction and control on the wave. Pin tails have the narrowest width of all the tails. Less width minimizes the tail's surface area allowing you to sink and dig into the water causing the board to track and maintain dire...

Read More
Learn more

Key features of the USC Have:

Old School outline ,inspired by the "Seventies Single Fin Era".

Wide point is forward for lots of paddle power, but narrower tail width to still work in the pocket.

Rocker is flatter under the front foot, for lots of drive but still has nose lift and a nice balanc...

Read More
Order online

Rome wasn't built in a day and fine surfboards take a little bit of time to make ! Custom boards normally take four to six weeks to make , depending on a few different factors . Consider, artwork , model (type of design) and amount of orders at that time . Complex boards with channels and intrica...

Read More
Learn more

The TP1 is a Twin Fin set up but with the third rear box. It's not a "thruster" , the fin set up is "Two Plus One" so you can add a small rear Fin when needed or ride it as a Twin,options are limitless.

Harry rides the TP1 with Scarfini Twins and knubster third fin in the rear . A lot surfers ...

Read More

The Must is an all-rounder designed to sit just above your grovel/ junky wave model. But still able to work on low period type surf and up to 4ft Indo type waves.

Learn more

This is the USC Savage , designed for real good waves.PRO–SURFER BRENT SAVAGE ,signature all round performance modern short board . Designed to work on and above the lip. Now available after much research, development and refining by Brent in our patented USC Range , No hesitation, no holding bac...

Read More
Order online

About us

Surfboards "BUILT TO LAST & DESIGNED TO PERFORM". Proudly Made in Australia.

Contact Us


Call now
  • 0418 798 209
  • 070-4385-2652


Get directions
10/48 Machinery Drive
Tweed Heads South NSW 2486

Business Hours

Mon:10:00 AM – 4:00 PM
Tue:10:00 AM – 4:00 PM
Wed:10:00 AM – 4:00 PM
Thu:10:00 AM – 4:00 PM
Fri:10:00 AM – 4:00 PM
Get quote
Message sent. We'll get back to you soon.